Bronkhorst CoriCalc Manuel d'utilisateur

CoriCalc Calculation tool for (mini) CORI-FLOW® instruments Instruction manual Doc nr.: 9.17.056 A Date: 07-01-2009

page 10 9.17.056 The unit in which the pressures and the flow can be supplied can be selected at the Units frame at the bottom of the window. For pre

9.17.056 page 11 4.1.3.4 Maximum pressure outlet (sensor only) When this option has been selected, the maximum pressure outlet available after the

page 12 9.17.056 5 Troubleshooting, errors and warnings When calculating, CoriCalc performs many checks. Good results, which may lead to reliable ap

9.17.056 page 13 6 Fluid properties for manual input Fluid Density (kg/m3) Dynamic Viscosity (mPa.s) Phase Remark AIR Air 1.293 1.715e-2 Gas

page 14 9.17.056 7 Disclaimer Because of the various hardware and software environments into which Bronkhorst software may be put, this software and

page 2 9.17.056 Scope of this manual This instruction manual covers the operation of the software tool CoriCalc, provided by Bronkhorst Cori-Tech B.V

9.17.056 page 3 Table of contents 1 General description...

page 4 9.17.056 1 General description CoriCalc is a software program for calculating important sizing parameters for applications with (mini) CORI-F

9.17.056 page 5 2 System requirements 2.1 Personal Computer Minimum requirements: Pentium PC - 700 MHz / 32 MB internal RAM 20 MB free disk space

page 6 9.17.056 3 Installation and startup of CoriCalc 3.1 Installation Follow the on-screen instructions when installing CoriCalc. The default ins

9.17.056 page 7 4 Operation 4.1 Main window layout When CoriCalc is started, the main window is shown. Example for sensor only. Figure 1 - The C

page 8 9.17.056 4.1.1 Instrument Example of controller for water application. Figure 2 - The CoriCalc main window for controller calculations for

9.17.056 page 9 4.1.2 Input parameters Before any calculation can be made, the fluid (gas or liquid) needs to be selected from the pull-down list